Programming guidelines 47
3. Programming guidelines
Only the Supervisor is allowed to program the menus, Electrode,
Reagent, and Method.
To select the Supervisor mode, press Stop for 3 seconds in the Main
window and enter the Supervisor code. Press 5 (Exit) and select
Return in mode = Supervisor.
* IMPORTANT *
For rst time users, it is recommended to program the instrument as
follows:
1. Create the electrode(s) to be used to perform the measurements.
2. Create the reagent(s) to be used during the titration.
Then nally,
3. Create the method(s), which will consequently use the electrode(s)
and reagent(s) created in the rst two steps of programming.
Once you have nished programming, make sure that NO question
marks "?" are displayed in the Reagent and Electrode tabs!
To Next Page
Loading...
Need help?
General
