Radiometer Analytical TitraLab TIM960 - Programming Reagent Parameters

Programming guidelines 43
Programming reagent parametersProgramming reagent parameters
Programming reagent parametersProgramming reagent parameters
Programming reagent parameters
1. If Titre = Calibrate, enter the reagent definition parameters
and go to the last Edit method screen.
2. Press 1:
To enter Calibration parameters: general parameters
used during the calibration.
3. Press 2:
To enter Standard parameters concerning the standard solution
used for the calibration.
4. Press 3:
To enter the Results parameters concerning acceptation criteria
that you can set on the results and stoichiometric coefficients for
the chemical reaction (if required).
5. Press 4:
To enter Printouts parameters defining the calibration report to
be printed.