RADIOMETER FLEX ABL90 User Manual

Changing consumables, continued
Changing the thermal printer paper
• Show how to enter Analyzer Status on the analyzer screen and find
> Consumables > Replace > Paper
• Show where to find and press the release button to open the cover and
remove the used paper roll
• Let the trainee place the new paper roll, tell or show that the paper
must unwind from below
• Let some paper extend out of the printer
• Close the cover and tell that the cover must “click” to be correctly in
place
• Point to the analyzer screen and complete the procedure
Training method
Demonstrate with participation of the trainee how to replace a consumable in a slow step-by-step
guidance. Emphasize how the analyzer provides feedback (sound and light indications) and provides
on-screen guidance throughout the process.
16
16 of 36EXT-VEND-MAN-0023-1 Owner:Julie Monnox Approved:27 Mar 2019

RADIOMETER FLEX ABL90 Specifications

General

Analyzer Type	Blood Gas Analyzer
Analysis Time	35 seconds
User Interface	Touch screen
Power Supply	100-240 V AC, 50/60 Hz
Parameters Measured	pH, pCO2, pO2
Sample Type	Whole blood
Sample Volume	65 µL
Calibration	Automatic
Connectivity	USB, Ethernet
Operating Temperature	15-30°C
Operating Humidity	20-85% relative humidity, non-condensing