RADWAG AS series

56
• Set n – set quantity of repetitions performed during pipettes calibration
(5 ÷ 15),
• Set t – set temperature for performing pipettes calibration (0,4 ÷ 25,5 °C),
• Set P – set pressure of room where pipettes calibration is performed
(800 ÷ 1050 hPa),
• Set h – set humidity of room where pipettes calibration is performed
(10 ÷ 95 %),
• V
0
– initial volume of pipette (introduced by laboratory assistant),
• V
1/2
– 50% of pipette volume (introduced by laboratory assistant),
• V
1
– nominal volume of pipette (introduced by laboratory assistant).