EasyManuals Logo
Home>RADWAG>Scales>PS Series

RADWAG PS Series Operating Instructions

RADWAG PS Series
74 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #10 background imageLoading...
Page #10 background image
10
4. UNPACKING, INSTALLATION AND COMMISSONING
4.1. Installation and operation place
Balance should be stored and used in locations free of vibrations and
shakes, free of wind and dust.
Air temperature should not exceed range between:
+10
o
C ÷ +45
o
C
Humidity of air should not exceed 80% (not condensing).
When operating the balance, room temperature should not change more
than 0,5
°
C within one hour,
The balance should be placed on a stable surface not affected by vibrations
and distant from heat sources.
Please take special safety measures when weighing magnetic loads, as part
of this balance is a strong magnet. If there is a necessity to perform
measurement of such load, please use option of under hook weighing, which
removes the load from area influenced by the magnet. For installation place
of under hook device, please look at the bottom casing of the balance,.
Avoid static charging of items to be weighed, or weighing container. In case
of static discharges may occur, please ground the device. Grounding bolt is
placed at the back side of the balance’s casing.

Table of Contents

Other manuals for RADWAG PS Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the RADWAG PS Series and is the answer not in the manual?

RADWAG PS Series Specifications

General IconGeneral
BrandRADWAG
ModelPS Series
CategoryScales
LanguageEnglish

Related product manuals