RADWAG PS Series - Control of % Deviation Referring Mass of Standard; Mass of Standard Determined by Its Weighing

53
13.3. Control of % deviation referring mass of standard
Balance software enables control of deviation (in %) of weighed loads mass
referring mass of standard. Mass of standard can be determined by its
weighing (PERC A function) or entered to balance memory by user (PERC B
function).
13.3.1. Mass of standard determined by its weighing
Proc
edure:
• Enter to function
• place on the pan load which mass will be accepted as standard
• press ENTER/PRINT to confirm this operating mode
• after few seconds indication 100,00% will be displayed.