To Next Page

To Previous Page

4.3. Positioning

Before switching on the balance, please level the device

with two adjusting feet situated at the back of the casing.

Please level the balance so that the air bubble of the level

is placed centrally.

4.4. Standard accessories

• Bala

nce.

• Weighing pan and protecting elements.

• Power adapter.

• User manual.

4.5. Cleaning

Bala

nce should be cleaned with damp cloth. In order to clean the weighing pan

of the balance, please remove it from the weighing chamber. Cleaning of the

pan when installed may cause damage of the measuring system of the

balance.

4.6. Connection to mains

Bala

nce can be connected to mains only with a power adapter offered as

standard accessory to the balance. Nominal power supply of the power adapter

(specified on the data plate of the power adapter) should be compatible to the

power from mains. Please plug the adapter the socket at the back of the

balance, the display with light on and show sequence of digits – display test),

after which balance will display 0.0000g. if indication is different from zero,

please press ESC/TARA button.

4.7. Connection of additional equipment

he balance must be disconnected from the mains before connecting or

disconnecting additional equipment (printer, PC) to or from the data interface.

Use only accessories and peripheral equipment recommended by the

manufacturer with your balance. These have been ideally coordinated to your

balance.

RADWAG PS Series Operating Instructions

Other manuals for RADWAG PS Series