RADWAG PS Series Operating Instructions

70
1 - 3 4 5 6 7 8 - 16 17 18 - 20 21 22
Command
space
stability
marker
space
mark
mass
space
unit
CR
LF
Command – 1 ÷ 3 marks
stability marker – [space] if stable
[?] if unstable
[^] if there is an error of exceeding the range on +
[v] if there is an error of exceeding the range on -
mark – [space] for positive values or [-] for negative values
mass – 9 marks alignment to the right
unit – 3 marks alignment to the left
16. WEIGHING LOADS UNDER BALANCE
In standard analytical and precision balances can weigh load on suspension.
To use this function:
• Remove plastic plug in basic of balance
• There is suspension in the basic of balance. It’s installed for good.
• Install hook to hang load (hook isn’t standard equipment for balance), weigh
load on hook.
Attention:
• Suspension cannot be turned around, move or manipulate. Mechanism of
balance can be damaged this way.
• Mass all additional elements as balance, string should be settled to zero
by pressing key Esc/TARE.

RADWAG PS Series Specifications

General

Category	Scales
Brand	RADWAG
Series	PS
Capacity	Varies by model
Readability	Varies by model
Pan Size	Varies by model
Display	LCD
Housing	Plastic
Repeatability	Varies by model
Linearity	Varies by model
Calibration	Internal or external
Interface	RS232
Power Supply	100 - 240V AC
Operating Temperature	+15 ÷ +30 °C
Weighing Unit	g, lb, oz