RADWAG PS Series Operating Instructions

18
Don’t unplug the balance from power supply between following measurements.
Switch the balance off by pressing ON/OFF key. If user presses key ON/OFF once
again balance is ready to following measurements
8.1. Choice of basic weighing unit
Function is used to setting the initial unit with which the balance will start after
switching on. Enter to submenu P5 Unit,
press several times UNITS key. Display will indicate by turns available
units.

RADWAG PS Series Specifications

General

Category	Scales
Brand	RADWAG
Series	PS
Capacity	Varies by model
Readability	Varies by model
Pan Size	Varies by model
Display	LCD
Housing	Plastic
Repeatability	Varies by model
Linearity	Varies by model
Calibration	Internal or external
Interface	RS232
Power Supply	100 - 240V AC
Operating Temperature	+15 ÷ +30 °C
Weighing Unit	g, lb, oz