RADWAG PS Series Operating Instructions

26
9.3. Autozero function
In order to ensure precise indication of balance, „AUTOZERO” function was
introduced. The application of this function is automatic control and correction
of zero indication of balance.
When function is active comparison of results takes place at declared time
intervals e.g. every 1 s, only when the pan is unloaded and results are close to
zero.
If results vary by value smaller than declared AUTOZERO range e.g. one
division, balance will zero automatically and stable result marker– and
zero indication – will be displayed.
When AUTOZERO function is on each result starts from precise zero. However
there are some cases where this function can be disturbance at
measurements. Such instance is very slow placing of load on the pan (e.g. load
pouring) in such case correction system of zero indication can also correct
indication of real mass of load.
Procedure:
AUTOZERO OFF – autozero off
AUTOZERO On - autozero on.
Return to weighing
(see - 7.1.2. – return to weighing).

RADWAG PS Series Specifications

General

Category	Scales
Brand	RADWAG
Series	PS
Capacity	Varies by model
Readability	Varies by model
Pan Size	Varies by model
Display	LCD
Housing	Plastic
Repeatability	Varies by model
Linearity	Varies by model
Calibration	Internal or external
Interface	RS232
Power Supply	100 - 240V AC
Operating Temperature	+15 ÷ +30 °C
Weighing Unit	g, lb, oz