RADWAG PS Series Operating Instructions

34
P1.1 iCAL – Internal calibration
start of internal calibration process, process is completely automatic without
interference of balance operator, if pan is loaded display will indicate message
about necessity of removing the load.
or CAL button
P1.2 ECAL – External calibration
calibration with external weight, which value is saved in factory menu of
balance, function unavailable in verified balances.
balances with internal calibration balances with external calibration
P1.3 tCAL - Test of calibration
comparison of internal calibration mass with its value saved in balance memory.
balances with internal calibration balances with external calibration
P1.4 ACAL – Automatic calibration (balances with internal calibration)
determination of factor, which should decide about starting the automatic internal
calibration
nonE – none of factors will cause start of calibration
tEmP – calibration with regard to change of temperature
timE – calibration with regard to time set in P1.5 CALt
both – calibration with regard to time and temperature.

RADWAG PS Series Specifications

General

Category	Scales
Brand	RADWAG
Series	PS
Capacity	Varies by model
Readability	Varies by model
Pan Size	Varies by model
Display	LCD
Housing	Plastic
Repeatability	Varies by model
Linearity	Varies by model
Calibration	Internal or external
Interface	RS232
Power Supply	100 - 240V AC
Operating Temperature	+15 ÷ +30 °C
Weighing Unit	g, lb, oz