QRAE II User Guide
Page 34
Clear All Data. You can clear all data from the datalog. The QRAE II has a challenge
that asks you to confirm that you want to clear the data.
1. Press [Y/+]. The display shows:
Are you sure?
2. Press [Y/+] to clear the datalog or [MODE] if you do not want to clear the
datalog. If you choose to clear it, the display shows:
Datalog cleared!
If you press [MODE], the display shows:
Datalog not cleared.
Important! If you clear the datalog’s data, it cannot be retrieved, or “unerased.”
Change Datalog Period. The datalogging interval can be set from 1 second to 3,600
seconds (60 minutes). This is the time between data points. The QRAE II can store
64,000 datapoints.
1. Press [MODE] to step from Save and Quit and to advance through the digits.
2. Press [Y/+] to advance from 0 through 9. If you press [Y/+] when 9 is selected, it
“wraps” around to 0 and begins counting up again each time you press [Y/+].
3. Press [MODE] to step to the next digit.
4. Press [Y/+] to advance from 0 through 9. Repeat steps 3 and 4 until you advance
to Save or Quit.
5. Press [Y/+] to commit your change or to exit to the next menu item.
Select Data Type. You have three choices for the type of data collected in the QRAE II.
You may select one. The screen shows:
Switch mode?
Your choices are:
Average
Peak
Minimum
Press [MODE] to move from the up arrow to the down arrow to Save and to Quit. When
the cursor is on the choice you want, press the [Y/+] key.
To Next Page
Loading...
Need help?
General
