ToxiRAE Pro User’s Guide
33
numbers increase from 0 to 9. Once 9 is reached, pressing [Y/+] again “wraps”
around back to 0.
Note: The last four characters must be numerals.
3. Press [MODE] to advance to the next character.
Repeat this process until all eight characters of the new Site ID are entered.
To save your new Site ID and exit, press [MODE] repeatedly until “OK” is highlighted.
Then press [Y/+].
User ID
Enter an 8-digit alphanumeric User ID to uniquely identify a user. This User ID is
included in the datalog report.
1. Press [Y/+] and the display shows the current User ID. Example: “USER0000.”
The left-most character is highlighted.
2. Press [Y/+] repeatedly to select a desired character. Letters increase from current
value to Z followed by digits from 0 to 9. Once 9 is reached, pressing [Y/+] again
“wraps” around to the letter A.
3. Press [MODE] to advance to the next character.
Repeat this process until all eight characters of the new User ID are entered.
To save your new User ID and exit, press [MODE] repeatedly until “OK” is highlighted.
Then press [Y/+].
User Mode
The ToxiRAE Pro has two user modes:
Basic Basic users can only see and use a basic set of functions.
Advanced Advanced users can see all screens and take advantage of all available
functions.
Note: The default value for User Mode is Basic.
To change the User Mode:
1. Press [MODE] to step from one option to the other. The highlighting changes
each time you press [MODE].
2. Press [Y/+] to make your selection (the dark circle in the “radio button” indicates
the option has been selected).
3. When you have completed your selection, press [MODE] repeatedly until “Exit”
is highlighted.
4. Press [Y/+] to register your selection, exit the User Mode submenu and advance
to Date.
To Next Page
Loading...
