ESP-ME3 Controller
10
EN
Basic Programming
1. Set Date and Time
Turn the dial to Date / Time
A
Press or to select the setting to change.
B
Press or to change the setting value.
C
Press and hold or to accelerate adjustments.
To change the time format (12 hour or 24 hour):
A
With Day of Month blinking, press .
B
Press or to select the desired time format,
then press to return to the date setting.
2. Set Watering Start Times
Up to six Start Times are available for each program.
Turn the dial to Start Times
A
Press Program Select to choose the desired
Program (if necessary).
B
Press or to select an available Start Time.
C
Press or to set the selected Start Time
(ensure the AM/PM setting is correct).
D
Press to set additional Start Times.
NOTE: The OFF Position for any start time is
between 11:45 PM and 12:00 AM.
3. Set Station Run Times
Run Times can be set from one minute up to six hours.
Turn the dial to Run Times
A
Press Program Select to choose the desired
Program (if necessary).
B
Press or to select a Station.
C
Press or to set the Run Time for the selected
Station.
D
Press to set additional Station Run Times.
NOTE: Only assign Run Times in a Program for
stations you want to water. If you do not want a
specific station to run in a selected program then
set the Run Time to zero.
NOTE: Rain Bird recommends that the maximum
irrigation station cycle time be less than the time
required for runoff to begin and that there be
adequate soak time before the next irrigation
cycle of that same station begins again.
4. Set Water Days
Custom Days of the Week
Set watering to occur on specific days of the week.
Turn the dial to Water Days
A
Press Program Select to choose the desired
Program (if necessary).
B
Press or to set the selected (blinking) day as
either ON or OFF, and to automatically move to
the next day.
C
Press or at any time to move the cursor to the
previous or next day.
NOTE: With Sunday selected, press the button
to enter and activate Cyclic Watering (see the
Advanced Programming section). If this is not
desired, press the button to return to watering
by Custom Days.
To Next Page
