Raise3D Pro3 HS Series - Page 12

Raise3D Pro3 HS Series Printer User Manual Declarations and Safety Statements
9
1. Installation
To facilitate operation and maintenance, maintain a proper distance of 50 cm on the side
of the printer, 80 cm on the front, 20 cm on the back, and 60 cm on the top during
installation. No flammable materials are allowed around the installation location.
Note: During low-temperature transportation, the printer may encounter frost or icing
hazards. The printer can be stored at room temperature for 4-6 hours before operating.
2. Filament and Electrical Precautions
It is strongly recommended to use Raise3D official filaments and/or default settings for
better performance. The Raise3D printer is designed to be highly compatible with
Raise3D official filaments. Be extremely careful when printing with unverified filaments
and settings to prevent abnormal printing results or damaging the printer.
Warning: The printer belongs to EN55032 Class A. In a residential environment, the
printer may cause radio interference.
3. Odor
The printer emits a thermoplastic smell when in operation.
Note: Place the printer in a well-ventilated and dry environment.
Oil in the air accumulating inside the printer may damage plastic parts. Air in a cavity
with excessive solid particles (conductive or non-conductive) may cause damage to the
printer