Raise3D Pro3 HS Series - Page 8

Raise3D Pro3 HS Series Printer User Manual Safety Precautions
5
 Do not touch the edge of the spatula.
 Keep children away from the spatula.
▪ Some parts in the printer are sharp and may cause injury.
▪ When removing the printing model, please refer to the Chapter of Remove the Printed
Model.
CAUTION - Risk of burns!
▪ When operating or printing at high temperatures, the shell of the appliance becomes
hot.
 Do not touch the build plate when the printer is heating up.
 Please wear the heat-insulating gloves provided in the accessory box for operation.
 Please keep children away from the heated build plate.
▪ The temperature of the extruder is very high when it is printing.
 Please do not touch the extruder when it is heating.
 Please wear the heat-insulating gloves provided in the accessory box for operation.
 Please keep children away from the heated extruder.
Safe Maintenance
Take note of the safety instructions when performing maintenance work on the appliance.
WARNING - Risk of electric shock!
▪ Improper repairs are dangerous.
 Repairs to the appliance should only be carried out by trained specialist staff.
 Only use the manufacturer's original spare parts and original accessories when
repairing the appliance.
 If the power cord of this appliance is damaged, it must be replaced by the
manufacturer, the manufacturer's Customer Service or a similarly qualified person in
order to prevent any risk.
▪ An ingress of moisture can cause an electric shock.
 Do not use steam cleaners or sprays to clean the appliance.
WARNING - Risk of injury!
▪ The use of non-original spare parts and non-original accessories is dangerous.
 Only use the manufacturer's original spare parts and original accessories.