182 STARTING AND OPERATING
LANESENSE — IF EQUIPPED
LANESENSE OPERATION
The LaneSense system is operational at speeds
above 37 mph (60 km/h) and below 112 mph
(180
km/h). The LaneSense system uses a
f
or
w
a
rd looking camera to detect lane markings
and measure vehicle position within the lane
boundaries.
When both lane markings are detected and the
driv
er drifts out of the lane (no turn signal applied),
the LaneSense system provides a haptic warning
in the form of torque applied to the steering wheel,
as well as a visual warning in the instrument
cluster display, to prompt the driver to remain
within the lane boundaries.
The driver may manually override the haptic
warn
ing by applying force into the steering wheel at
any time.
When only a single lane marking is detected and
the
driver drifts across the lane marking (no turn
signal applied), the LaneSense system provides a
visual warning through the instrument cluster
display to prompt the driver to remain within the
lane.
When only a single lane marking is detected, a
hapt
ic or a torque warning will not be provided.
NOTE:
When operating conditions have been met, the
LaneS
ense system will monitor if the driver’s
hands are on the steering wheel and provide an
audible and visual warning to the driver if removed.
The system will cancel if the driver does not return
their hands to the wheel.
TURNING LANESENSE ON OR OFF
The LaneSense button is located on the
switch panel below the Uconnect display.
NOTE:
If your vehicle is equipped with a 12-inch Uconnect
Disp
lay screen, the LaneSense button is located
above the display.
To turn the LaneSense system on, push the
LaneS
ense button (LED turns off). A “LaneSense
On” message is shown in the instrument cluster
display.
To turn the LaneSense system off, push the
LaneS
ense button again (LED turns on).
NOTE:
The LaneSense system will retain the last system
stat
e on or off from the last ignition cycle when the
ignition is placed in the ON/RUN position.
LANESENSE WARNING MESSAGE
The LaneSense system will indicate the current
lane drift condition through the instrument cluster
display.
When the LaneSense system is on, the lane lines
are
gray when both of the lane boundaries have
not been detected and the LaneSense telltale
is solid white.
System ON (Gray Lines) With White Telltale
To Next Page
Loading...
