184 STARTING AND OPERATING
When the LaneSense system senses the lane
has been approached and is in a lane departure
situation, the left lane line flashes yellow (on/
off). The LaneSense telltale
changes from
solid yellow to flashing yellow. At this time
t
orqu
e is applied to the steering wheel in the
opposite direction of the lane boundary.
For example: If approaching the left side of the
lane
the steering wheel will turn to the right.
Lane Approached (Flashing Yellow Lane Line)
With
Flashing Yellow Telltale
NOTE:
The LaneSense system operates with similar
beha
vior for a right lane departure.
CHANGING LANESENSE STATUS
The LaneSense system has settings to adjust the
intensity of the torque warning and the warning
zone sensitivity (Early/Medium/Late) that you can
configure through the Uconnect system
Ú page 216.
NOTE:
When enabled the system operates above
37
mph (60 km/h) and below 112 mph
(
1
8
0
km/h).
The warnings are disabled with use of the turn
signal.
The system will not apply torque to the steering
wheel whenever a safety system engages
(Anti-Lock Brakes, Traction Control System,
Electronic Stability Control, Forward Collision
Warning, etc.).
PARKVIEW REAR BACK UP CAMERA
The ParkView Rear Back Up Camera allows you to
see an on-screen image of the rear surroundings of
your vehicle whenever the gear selector is put into
REVERSE. The image will be displayed on the
Navigation/Multimedia radio display screen along
with a caution note to “Check Entire Surroundings”
across the top of the screen. After five seconds this
note will disappear. The ParkView Camera is
located in the center of the tailgate handle.
NOTE:
Removing the tailgate will disable the rearview
came
ra function.
Manual Activation Of The Rear View
Camera:
1. P
ress the "Controls" button located on the
bot
tom of the Uconnect display.
2. Press the "Back Up Camera" icon to turn the
Rea
r View Camera system on.
NOTE:
The ParkView Rear Back Up Camera has program-
mable modes of operation that may be selected
t
hrou
gh the Uconnect system Ú page 216.
When the vehicle is shifted out of REVERSE (with
c
ame
ra delay turned off), the rear camera mode is
exited and the previous screen appears. When the
vehicle is shifted out of REVERSE (with camera delay
turned on), the camera image will continue to be
displayed for up to 10 seconds after shifting out of
REVERSE unless the following conditions occur: The
vehicle speed exceeds 8
mph (13 km/h), the vehicle
is s
hifted into PARK, the vehicle’s ignition is placed
in the OFF position, or the user presses image defeat
“X” to exit out of the camera video display.
To Next Page
Loading...
