GETTING TO KNOW YOUR VEHICLE 47
ERASING ALL THE HOMELINK®
C
HANNELS
To erase the channels, follow this procedure:
1. P
lace the ignition switch into the ON/RUN
p
o
s
ition.
2. Push and hold the two outside HomeLink®
but
tons (I and III) for up to 20 seconds, or until
the HomeLink® indicator light flashes.
NOTE:
Erasing all channels should only be performed
when
programming HomeLink® for the first time.
Do not erase channels when programming addi
-
tional buttons.
IDENTIFYING WHETHER YOU HAVE A
R
OLLING CODE OR NON-ROLLING CODE
D
EVICE
Before programming a device to one of your
HomeLink® buttons, you must determine whether
the device has a rolling code or non-rolling code.
Rolling Code Devices
To determine if your device has a rolling code, a
g
ood i
ndicator is its manufacturing date. Typically,
devices manufactured after 1995 have rolling
codes. A device with a rolling code will also have a
“LEARN” or “TRAIN” button located where the
antenna is attached to the device. The button may
not be immediately visible when looking at the
device. The name and color of the button may vary
slightly by manufacturer.
NOTE:
The “LEARN” or “TRAIN” button is not the button
you n
ormally use to operate the device.
Non-rolling Code Devices
Most devices manufactured before 1995 will not
have
a rolling code. These devices will also not
have a “LEARN” or “TRAIN” button.
PROGRAMMING HOMELINK® TO A
G
ARAGE DOOR OPENER
To program any of the HomeLink® buttons to
activate your garage door opener motor, follow the
steps below:
NOTE:
All HomeLink® buttons are programmed using this
proce
dure. You do not need to erase all channels
when programming additional buttons.
1. Place the ignition switch into the ON/RUN
pos
ition.
2. Place the garage door opener transmitter 1 to
3
in
ches (3 to 8 cm) away from the
Hom
e
L
i
nk® button you wish to program, while
keeping the HomeLink® indicator light in view.
3. Push and hold the HomeLink® button you
wan
t to program while you push and hold the
garage door opener transmitter button you are
trying to replicate.
4. Continue to hold both buttons and observe the
HomeLi
nk® indicator light. The HomeLink®
indicator light will flash slowly and then rapidly.
Once this happens, release both buttons.
NOTE:
Make sure the garage door opener motor is
plug
ged in before moving on to the rolling code/
non-rolling code final steps.
Rolling Code Garage Door Opener Final Steps
NOTE:
You have 30 seconds in which to initiate rolling
code
final step 2, after completing rolling code
final step 1.
1. At the garage door opener motor (in the
gara
ge), locate the “LEARN” or “TRAIN”
button. This can usually be found where the
hanging antenna wire is attached to the
garage door opener motor. Firmly push and
release the “LEARN” or “TRAIN” button.
2. Return to the vehicle and push the
prog
rammed HomeLink® button three times
(holding the button for two seconds each
time). If the garage door opener motor
operates, programming is complete.
2
To Next Page
Loading...
