96 GETTING TO KNOW YOUR VEHICLE
Second Panel Position
NOTE:
Unfold the panel gently, and do not allow the
pane
ls to drop under their own weight.
7. Completely unfold the Tonneau Cover.
Pos
ition Two (Fully Unfolded)
8. Repeat steps 2 through 3 for the rear pair of
lat
ches.
9. Pull down on the handle to ensure the Slide
Locki
ng Lever is fully engaged. Do this for both
the left and right side.
NOTE:
Also check to ensure the bumper is forward of the
bead
on the underside of the truck flange. Make
sure that the Tonneau Cover is positioned fully
forward, so that the bumper clears the bead.
Pull Up On Tonneau Cover Corners
10. Gently pull up on all four corners of the
Tonn
eau Cover to ensure that it is properly
latched.
TRI-FOLD TONNEAU COVER CLEANING
For proper cleaning of the Tonneau Cover, use
Mopar® Whitewall & Vinyl Top Cleaner and
Mopar® Leather & Vinyl Conditioner/Protectant.
CAUTION!
The vehicle cannot be driven when the Tonneau
Cover is in the second panel position.
CAUTION!
It is the driver’s responsibility to ensure the
Tonneau Cover is properly installed on the
vehicle. Failure to follow this procedure can
result in detachment of the Tonneau Cover from
the vehicle and/or damage to the vehicle/
Tonneau Cover.
To Next Page
Loading...
