IN CASE OF EMERGENCY 351
Front Jacking Location
When changing a front wheel, place the scis-
sor jack under the rear portion of the lower
c
ontr
ol arm as shown. Access the front jacking
location from behind the front tire.
Front Lifting Point
Front Jacking Location
Rear Jacking Location
Operate the jack using the extension with jack
h
ook a
nd the lug wrench. The extension tubes
may be used but are not required.
When changing a rear wheel, assemble the ex-
tension with jack hook to the jack and connect
t
he
extension tubes. Access the rear jacking lo-
cation from behind the rear tire.
Pla
ce the jack
under the Jack Lifting Point located on the rear
axle lower control arm bracket. Then locate the
slot in the jack lift plate onto the rear axle Jack
Lifting Point. Attach the extension with jack
hook extending to the rear of the vehicle.
Rear Lifting Point
Rear Jacking Location
Connect the long extensions to the lug wrench.
5. By rotating the lug wrench clockwise, raise the
veh
icle until the wheel just clears the ground
surface.
CAUTION!
Before raising the wheel off the ground, make
sure that the jack will not damage surrounding
truck parts and adjust the jack position as
required.
WARNING!
Raising the vehicle higher than necessary can
make the vehicle less stable. It could slip off the
jack and hurt someone near it. Raise the vehicle
only enough to remove the tire.
7
To Next Page
Loading...
