R&S ESU Series - Page 282

Operating Manual 1302.6163.12 - 03 4.251
R&S ESU Instrument Functions
Basic Settings
2nd press: The line is switched off (softkey with gray background).
Initial situation: The line is on (softkey with green background)
1st press: The data input function is activated (softkey with red background). The
position of the display line can be selected by means of the rotary knob, the step
keys or a numerical entry in the appropriate field. The data input function is disabled
if another function is activated. The line, however, remains switched on (softkey with
green background).
2nd press: The line is switched off (softkey with gray background).
DISPLAY
LINES
DISPLAY LINE 1
/
DISPLAY LINE 2
The DISPLAY LINE 1/2 softkeys enable or disable the level lines and allow the user
to enter the position of the lines.
The level lines mark the selected level in the measurement window.
Remote command: CALC:DLIN:STAT ON
CALC:DLIN -20dBm
FREQUENCY
LINE 1/
FREQUENCY
LINE 2
The FREQUENCY LINE 1/2 softkeys enable or disable the frequency lines 1/2 and
allow the user to enter the position of the lines.
The frequency lines mark the selected frequencies in the measurement window.
Remote command: CALC:FLIN:STAT ON
CALC:FLIN 120MHz
TIME LINE 1 /
TIME LINE 2
The TIME LINE 1/2 softkeys enable or disable the time lines 1/2 and allow the user
to enter the position of the lines.
The time lines mark the selected times or define search ranges (see section “Marker
Functions – MKR FCTN Key” on page 4.152).
DISPLAY LINE 1 /
DISPLAY LINE 2
FREQUENCY LINE 1/
FREQUENCY LINE 2
TIME LINE 1 /
TIME LINE 2
These softkeys are only available in the time domain (span = 0).
These softkeys are only available in the frequency domain (span > 0).
The two softkeys cannot be used in the frequency domain (span > 0).