Operating Manual 1302.6163.12 - 03 4.275
R&S ESU Instrument Functions
Basic Settings
Comment - Entry of comment
Any comment with a maximum length of 50 characters can be entered.
Remote command: CORR:TRAN:COMM <string>
INSERT LINE The INSERT LINE softkey inserts an empty line above the marked reference value.
When entering a new reference value in the line, the ascending order of frequencies
must be taken into consideration, however.
Remote command: --
DELETE LINE The DELETE LINE softkey deletes the marked reference value (complete line). The
reference values that follow move one line up.
Remote command: --
SAVE TRD
FACTOR
The SAVE TRD FACTOR softkey saves the changed table in a file on the internal
hard disk.
If there is already a transducer factor that has the same name, a confirmation query
is output.
If the new factor is active, the new values become immediately valid.
If a transducer set is switched on comprising the factor, the values will only be used
when the set is switched on next time.
Remote command: --
(executed automatically after the definition of the
reference values)
Entry and Editing of Transducer Sets
A transducer set is characterized by:
– maximum 10 ranges (Ranges) in which different transducer factors can be active
– the combination of several transducer factors per range (Factor)
– a transducer-set name (Name)
NEW / EDIT
The NEW and EDIT softkeys both open the submenu for editing and entering new
transducer factors if softkey TRANSDUCER SET is active.
INS BEFORE RANGE
INS AFTER RANGE
DELETE RANGE
RANGES 1-5/6-10
SAVE TRD SET
To Next Page
Loading...
