R&S ESU Series - Page 39

R&S ESU Instrument Functions
R&S ESU Initial Configuration – PRESET Key
4.8 Operating Manual 1302.6163.12 - 03
Table 4-2 ANALYZER SETUP of R&S ESU
Parameter Settings
Mode Spectrum
Center frequency step size 0.1 ×
center frequency
RF attenuation auto (10 dB)
Reference level -20 dBm
Level range 100 dB log
Level unit dBm
Sweep time auto
Resolution bandwidth auto (3 MHz)
Video bandwidth auto (10 MHz)
FFT filters off
Span / RBW 50
RBW / VBW 0,33
Sweep cont
Trigger free run
Trace 1 clr write
Trace 2/3 blank
Detector auto peak
Trace math off
Frequency offset 0 Hz
Reference level offset 0 dB
Reference level position 100 %
Grid abs
Cal correction on
Noise source off
Input RF 1, AC-coupled
Display Full screen, active screen A
Tracking generator (only with
option R&S FSP-B9)
off
External generator 1/2 (only
with option R&S FSP-B10)
off
Preamplifier off
Preselector off