R&S ESU Series - Page 450

Operating Manual 1302.6163.12 - 03 6.11
R&S ESU Remote Control – Description of Commands
ABORt Subsystem
6.4 ABORt Subsystem
The ABORt subsystem contains the commands for aborting triggered actions. An action can be triggered
again immediately after being aborted. All commands trigger events, and therefore they have no *RST
value.
ABORt
This command aborts a current measurement and resets the trigger system.
Example: "ABOR;INIT:IMM"
Characteristics: *RST value: 0
SCPI: conform
Mode: R, A
HOLD
This command interrupts a current scan measurement. The scan is resumed by “INITiate<1|2>[:
IMMediate]” on page 6.126
Example: "HOLD"
'interrupts the current scan measurement
Characteristics: *RST value: -
SCPI: conform
Mode: R