R&S ESU Series - Page 535

R&S ESU Remote Control – Description of Commands
CALCulate Subsystem
6.96 Operating Manual 1302.6163.12 - 03
CALCulate<1|2>:FLINe<1|2> 0 to f
max
This command defines the position of the frequency lines.
The frequency lines mark the frequencies specified in the measurement window. Frequency lines are
only available with SPAN > 0.
Example: "CALC:FLIN2 120MHz"
Characteristics: *RST value: - (STATe to OFF)
SCPI: device-specific
Mode: R, A-F
CALCulate<1|2>:FLINe<1|2>:STATe ON | OFF
This command switches the frequency line on or off.
Example: "CALC:FLIN2:STAT ON"
Characteristics: *RST value: OFF
SCPI: device-specific
Mode: R, A-F
CALCulate<1|2>:TLINe<1|2> 0 to 1000s
This command defines the position of the time lines.
The time lines mark the times specified in the measurement window. Time lines are only available with
SPAN = 0.
Example: "CALC:TLIN 10ms"
Characteristics: *RST value: - (STATe auf OFF)
SCPI: device-specific
Mode: A-T
CALCulate<1|2>:TLINe<1|2>:STATe ON | OFF
This command switches the time line on or off.
Example: "CALC:TLIN2:STAT ON"
Characteristics: *RST value: OFF
SCPI: device-specific
Mode: A-T