Operating Manual 1302.6163.12 - 03 6.105
R&S ESU Remote Control – Description of Commands
DISPlay Subsystem
Characteristics: *RST value: OFF
SCPI: device-specific
Mode: R, A
DISPlay:PSAVe:HOLDoff 1 to 60
This command sets the hold off time for the power-save mode of the display. The available value range
is 1 to 60 minutes, the resolution 1 minute. The entry is dimensionless.
Example: "DISP:PSAV:HOLD 30"
Characteristics: *RST value: 15
SCPI: device-specific
Mode: R, A
DISPlay:CMAP<1...34>:DEFault<1|2>
This command resets the screen colors of all display items to their default settings. Two default settings
DEFault1 and DEFault2 are available. The numeric suffix of CMAP is irrelevant.
Example: "DISP:CMAP:DEF2"
'Selects default setting 2 for setting the colors.
Characteristics: *RST value: --
SCPI: conform
Mode: R, A
This command is an event and therefore has no query and no *RST value.
DISPlay:CMAP<1...34>:HSL <hue>,<sat>,<lum>
This command defines the color table of the instrument.
Each numeric suffix of CMAP is assigned one or several graphical elements which can be modified by
varying the corresponding color setting. The following assignment applies:
CMAP1 Background
CMAP2 Grid
CMAP3 Function field + status field + data entry text
CMAP4 Function field LED on
CMAP5 Function field LED warn
CMAP6 Enhancement label text
CMAP7 Status field background
CMAP8 Trace 1
CMAP9 Trace 2
CMAP10 Trace 3
CMAP11 Marker
CMAP12 Lines
CMAP13 Measurement status + limit check pass
CMAP14 Limit check fail
CMAP15 Table + softkey text
CMAP16 Table + softkey background
To Next Page
Loading...
