R&S ESU Series - Page 556

Operating Manual 1302.6163.12 - 03 6.117
R&S ESU Remote Control – Description of Commands
HCOPy Subsystem
HCOPy:DESTination<1|2> <string>
This command selects the printer output medium (Disk, Printer or Clipboard) associated with
configuration 1 or 2.
Parameter: <string>::= 'SYST:COMM:GPIB' | 'SYST:COMM:SER' | 'SYST:COMM:CENT' |
'MMEM' | 'SYST:COMM:PRIN' | 'SYST:COMM:CLIP'
'MMEM': Directs the hardcopy to a file. Command MMEM:NAME '<file_name>'
defines the file name. All formats can be selected for HCOPy:DEVice:LANGuage.
'SYST:COMM:PRIN': Directs the hardcopy to the printer. The printer is selected
with command SYSTEM:COMMunicate:PRINter:SELect.
GDI should be selected for HCOPy:DEVice:LANGuage.
'SYST:COMM:CLIP': Directs the hardcopy to the clipboard. EWMF should be
selected for HCOPy:DEVice:LANGuage.
Example: "SYST:COMM:PRIN:SEL2 'LASER on LPT1'"
'Selects the printer and output medium for device 2
"HCOP:DEST2 'SYST:COMM:PRIN'"
'Selects the printer interface as device 2.
Characteristics: *RST value: -
SCPI: conform
Mode: R, A
This command is an event and therefore has no *RST value and no query.
HCOPy:DEVice:COLor ON|OFF
This command selects between color and monochrome hardcopy of the screen.
Example: "HCOP:DEV:COL ON"
Characteristics: *RST value: OFF
SCPI: conform
Mode: R, A
The type of instrument is selected with SYSTem:COMMunicate:PRINter:
SELect, which will automatically select a default output medium. Therefore the
command HCOPy:DESTination should always be sent after setting the device
type.