R&S ESU Series - Page 562

Operating Manual 1302.6163.12 - 03 6.123
R&S ESU Remote Control – Description of Commands
HCOPy Subsystem
HCOPy:TREPort:ITEM:PAGecount:STATe ON | OFF
In the current test report configuration, this command switches the output of the page numbering either
on or off.
Example: ":HCOP:TREP:ITEM:PAG:STAT ON"
Characteristics: *RST value: ON
SCPI: device-specific
Mode: R, A
HCOPy:TREPort:ITEM:SCANtable:STATe ON | OFF
In the current test report configuration, this command switches the output of the scan table with the
measurement settings either on or off.
Example: ":HCOP:TREP:ITEM:SCAN:STAT ON"
Characteristics: *RST value: ON
SCPI: device-specific
Mode: R, A
HCOPy:TREPort:ITEM:SRESults:STATe ON | OFF
In the current test report configuration, this command switches the output of the results on the
preliminary measurement in tabular format either on or off. Depending on the current scan settings,
this table can be very long in certain cases.
Example: ":HCOP:TREP:ITEM:SRES:STAT ON"
Characteristics: *RST value: OFF
SCPI: device-specific
Mode: R
HCOPy:TREPort:ITEM:TDSTamp:STATe ON | OFF
In the current test report configuration, this command switches the output of the date and time of day
at the start of the documented measurement either on or off.
Example: ":HCOP:TREP:ITEM:TDST:STAT ON"
Characteristics: *RST value: ON
SCPI: device-specific
Mode: R, A
HCOPy:TREPort:ITEM:TRANsducer:STATe ON | OFF
In the current test report configuration, this command switches the output of the enabled transducer
factor(s) either on or off.
Example: ":HCOP:TREP:ITEM:TRAN:STAT ON"
Characteristics: *RST value: OFF
SCPI: device-specific
Mode: R, A