R&S ESU Series - Page 561

R&S ESU Remote Control – Description of Commands
HCOPy Subsystem
6.122 Operating Manual 1302.6163.12 - 03
Mode: R, A
HCOPy:TREPort:ITEM:HEADer:LINE<1…7>:TITLe <string>
This command defines a name for the line of the report header indicated in the numeric suffix. This
name is also output in the test report.
Example: ":HCOP:TREP:ITEM:HEAD:LINE2:TITL 'Specification'"
Characteristics: *RST value:
LINE1 'Heading'
LINE2 'Meas Type'
LINE3 'Equipment under Test'
LINE4 'Manufacturer'
LINE5 'OP Condition'
LINE6 'Operator'
LINE6 'Test Spec'
SCPI: device-specific
Mode: R, A
HCOPy:TREPort:ITEM:HEADer: STATe ON | OFF
In the current test report configuration, this command switches the output of the report header either
on or off. The individual lines can also be controlled individually with ":HCOP:TREP:ITEM:HEAD:
LINE:CONT ALW | ONCE | NEV".
Example: ":HCOP:TREP:ITEM:HEAD:STAT ON"
Characteristics: *RST value: ON
SCPI: device-specific
Mode: R, A
HCOPy:TREPort:ITEM:DIAGram:STATe ON | OFF
In the current test report configuration, this command switches the output of the diagram on the test
instrument screen either on or off.
Example: ":HCOP:TREP:ITEM:DIAG:STAT ON"
Characteristics: *RST value: -
SCPI: device-specific
Mode: R, A
HCOPy:TREPort:ITEM:FRESults:STATe ON | OFF
In the current test report configuration, this command switches the output of the final measured values
in tabular format either on or off.
Example: ":HCOP:TREP:ITEM:FRES:STAT ON"
Characteristics: *RST value: ON
SCPI: device-specific
Mode: R