R&S ESU Series - Page 621

R&S ESU Remote Control – Description of Commands
SENSe Subsystem
6.182 Operating Manual 1302.6163.12 - 03
Example: "FREQ:MODE TDOM"
Characteristics: *RST value: TDOMain for the receiver mode and SWEep for the analyzer mode
SCPI: device-specific
Mode: R, A
In receiver mode, this command is available only with the option ESU-K53.
[SENSe<1|2>:]FREQuency:OFFSet <numeric_value>
This command defines the frequency offset of the instrument.
Example: "FREQ:OFFS 1GHZ"
Characteristics: *RST value: 0 Hz
SCPI: conform
Mode: A