Operating Manual 1302.6163.12 - 03 4.45
R&S ESU Instrument Functions
Receiver Mode
INTER
ACTIVE
The INTERACTIVE softkey selects the interactive mode for the final measurement
as described above.
Remote command: :FME:AUTO OFF
MEASURE The MEASURE softkey continues with the final measurement. The final measure-
ment starts at the next frequency entry on the peak list or at a marked frequency if
one or several lines have been skipped with the SKIP FREQUENCY softkey.
Remote command: --
STOP
FINAL MEAS
The STOP FINAL MEAS softkey halts the final measurement. The final measure-
ment starts from the beginning on a new start. The previously collected data is lost.
Remote command: --
Sequence for INTER ACTIVE
With the final measurement halted all receiver settings can be modified for example
for examining the signal in detail.
The mode of the measurement (automatic or interactive) can be selected again. The
final measurement can be skipped. The highest level measured can be sccepted by
GET MAXHOLD. The final measurement can be started with the MEASURE softkey.
Remote command: --
AUTOMATIC
FINAL
The AUTOMATIC FINAL softkey selects the automatic mode for the final measure-
ment (see above).
Remote command: :FME:AUTO ON
INTER
ACTIVE
The INTERACTIVE softkey selects the interactive mode for the final measurement
as described above.
Remote command: :FME:AUTO OFF
SIKP
FREQUENCY
The SIKP FREQUENCY softkey skips the final measurement and continues with the
prescan.
Remote command: --
HOLD SCAN AUTOMATIC FINAL
INTER ACTIVE
SIKP FREQUENCY
GET MAXHOLD
MEASURE
STOP SCAN
STOP FINAL MEAS
To Next Page
Loading...
