6 | Electrical connection
80.06.415_iVario2-XS-iVarioPro2-S_IM_en_US 31 / 52
NOTE
Damage to the holes for the electrical cabinet cover
Failure to follow the order for removing and tightening the screws for the
electrical compartment cover could result in damage to the holes due to the
preload in the cover.
The electrical compartment is located behind the right cover on the rear side of
the device.
a The device is positioned on the designated installation surface.
a The device covers are closed.
a A hex key (Torx Plus) is on hand.
a All voltage sources are switched off via an external circuit breaker.
1. Remove the silicone caps from the screws to be removed.
2. Remove the marked hex keys (1) and remove the cover by pulling it up-
wards (2).
To Next Page
Loading...
