EasyManuals Logo

Ravaglioli RAVTD3000HP User Manual

Ravaglioli RAVTD3000HP
54 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #31 background imageLoading...
Page #31 background image
Instruction manual
RAVTD3000 - RAVTD3000HP
RAVTD3000NRC - RAVTD3000ATS
Code M0215 - rev.1.1
(11/2012)RAVAGLIOLI S.p.A.
RAVAGLIOLI S.p.A. - Via I° Maggio, n° 3 (Pontecchio Marconi)
Page 29/52
40037 Sasso Marconi (Bologna - Italy)
Tel. 051/ 67.81.511 – Fax 051/ 84.64.67 E-mail: rav@ravaglioli.com
When you are in first position (approximately 15° forward on turn-tables), press F5 or the central
key on one of the two measuring heads.
“STOP” is displayed for about three seconds, i.e. the time needed by the programme to take the
measurements from the 1st point, after that, the programme shows the following page:
Figure 26
Start moving the vehicle backward, very slowly, until the vehicle arrow matches the target
point.
Figure 27
As soon as the vehicle matches the target point, “STOP” is displayed for about three seconds,
i.e. the time needed by the programme to take the measurements, after that, the programme
shows the following page:
Figure 28
Move vehicle forward again, until vehicle arrow matches target point (final point). “STOP” will
be displayed for approx. three seconds, and measurement readings acquired. The thrust out-
of-centre procedure has been completed.
Vehicle thrust
direction (back)
target point
Vehicle thrust
direction
Vehicle
matches target
point
Vehicle target
point

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Ravaglioli RAVTD3000HP and is the answer not in the manual?

Ravaglioli RAVTD3000HP Specifications

General IconGeneral
BrandRavaglioli
ModelRAVTD3000HP
CategoryMeasuring Instruments
LanguageEnglish

Related product manuals