Instruction manual
RAVTD3000 - RAVTD3000HP
RAVTD3000NRC - RAVTD3000ATS
Code M0215 - rev.1.1
(11/2012)RAVAGLIOLI S.p.A.
Page 4/52
RAVAGLIOLI S.p.A. - Via I° Maggio, n° 3 (Pontecchio Marconi)
40037 Sasso Marconi (Bologna - Italy)
Tel. 051/ 67.81.511 – Fax 051/ 84.64.67 E-mail: rav@ravaglioli.com
1 INTENDED USE
The RAVTD3000 system is an equipment designed for detection of all vehicle characteristic
angles. Applications: double axle cars and light commercial vehicles with wheelbases ranging
between 1800 mm (min.) and 4700 mm (max.).
Angles are detected by two sensors placed between the front and rear wheels, each fitted with
two Megapixel cameras which detect the spatial position of 4 three-dimension targets on the
wheels.
Infrared measurement of reciprocal angles between the sensors (no cable connection). Data
are transmitted from sensors to cabin VIA RADIO through modules
.
Machine operational temperature range: 0 to 40°C.
2 OPERATOR TRAINING
The machine must be used by specifically trained and authorised personnel, only. To ensure
proper machine use and that measurements can be efficiently taken, operators must be
correctly trained and acquire the skills consistent with the instructions provided by the
manufacturer. For any questions on the use and maintenance of the machine, please read
the instruction manual or the manuals supplied with the individual pieces of equipment (PC,
monitor, printer, ...) and then, if such doubts persist, contact an authorised after-sales centre
or RAVAGLIOLI S.p.A. technical assistance directly.
2.1 General Preventive Measures
Removal or changes made to safety devices, or warning signals on the machine can
cause serious hazards and represent a violation of European safety regulations.
Before doing any maintenance jobs on the system, always disconnect the power
supply.
In case of doubt, do not interpret, but contact RAVAGLIOLI S.p.A. technical
assistance in order to obtain instructions suitable for performing operations in total
safety.