15
b) Depressing momentarily steps the display from C-F to C-FC.
c) Depressing momentarily steps the display from C-FC to C-P.
d) Depressing momentarily steps the display from C-P to C-PC.
e) Depressing momentarily steps the display from C-PC to C-SD.
NOTE: If an entry selection error is made during steps 1-6, place the power ON/OFF
switch to OFF. Depress and hold while placing the power ON/OFF switch to
ON. This will reset the console.
The display will show CAL US-VOLUME PER ACRE. The following steps must be followed:
1) Display US-VOLUME PER ACRE, SI-VOLUME PER HECTARE, or TU-VOLUME PER 1000
SQ FT.
a) Depressing momentarily steps the display from
US-VOLUME PER ACRE to SI-VOLUME PER HECTARE.
b) Depressing momentarily steps the display from
SI-VOLUME PER HECTARE to TU-VOLUME PER 1000 SQ FT.
c) Depressing momentarily steps the display from
TU-VOLUME PER 1000 SQ FT to US-VOLUME PER ACRE.
2) Selecting US, SI, or TU.
a) To select US, SI, or TU, press until the desired code is displayed.
b) Momentarily depress , the display will now display CAL SP1-WHEEL DRIVE.
3) Display SP1-WHEEL DRIVE or SP2-RADAR SPEED SENSOR.
a) Depressing momentarily steps the display from SP1 to SP2.
b) Depressing momentarily steps the display from SP2 to SP1.
4) Selecting SP1 or SP2.
a) To select SP1 or SP2, press until desired code is displayed.
b) Momentarily depress , the display will now display
CAL C-SD-STANDARD VALVE.
5) Display C-SD-STANDARD VALVE, C-F-FAST VALVE, C-FC-FAST CLOSE VALVE,
C-P-PWM VALVE or C-PC-PWM CLOSE VALVE.
a) Depressing momentarily steps the display from C-SD to C-F.
To Next Page
Loading...
Need help?
General
