Raven SCS 660 Installation And Service Manual

27
14) BAUD RATE
A) RATE display will show "bAUd". DATA display will show "1200".
B) Depressing
momentarily changes the DATA display between "1200" and
"9600".
C) Momentarily depress
to advance to DATA LOGGER TRIGGER VALUE.
15) DATA LOGGER TRIGGER VALUE
A) RATE display will show "TriG". DATA display will show "0".
B) Enter the TRIGGER VALUE.
C) Momentarily depress
to advance to DATA LOGGER TRIGGER UNITS.
16) DATA LOGGER TRIGGER UNITS
A) RATE display will show "UniT". DATA display will show "FT"["nETr"].
B) Depressing
momentarily changes the DATA display between "FT" [nETr"]
and "SEC". A value of "FT"["nETr"] means feet [meters], or a value of "SEC"
means seconds have been chosen as the unit of measurement for the TRIGGER
VALUE programmed previously.
C) Momentarily depress
to advance to DATA LOGGER.
NOTE: The TRIGGER VALUE default value is "zero". This value must be change
to a desired number ranging from 1-9999. The DATA LOGGER features will
not work if this number is not changed.

Raven SCS 660 Specifications

General

Brand	Raven
Model	SCS 660
Category	Recording Equipment
Language	English