5
2. MOUNTING THE ENCODER
1) Mount Encoder on output shaft of conveyor, or other shaft which rotates at a known
ratio to the conveyor. (See Figures 5,6,7,& 8).
2) Apply grease to Encoder shaft, conveyor shaft, and Encoder coupler (fits 1"
diameter conveyor shaft). Secure coupler to Encoder and conveyor shafts with set
screws provided.
3) Install mounting tabs to Encoder as shown in Figure 4. Connect mounting tab to
mounting bracket (not provided) to prevent Encoder from rotating. DO NOT rigidly
mount Encoder. Encoder is to be supported by coupler ONLY.
FIGURE 4
To Next Page
Loading...
