29
13. DECIMAL SHIFT
The DECIMAL SHIFT feature is used to increase system accuracy at low application
rates. Shifting of the decimal point is done during the entry of METER CAL. After
entering METER CAL mode, depress the decimal shift key labelled
, enter
the meter calibration constant number, and depress
. The sequence to unshift
the decimals while in METER CAL is to enter the meter calibration constant number
and depress
.
The following table illustrates how shifting the decimal point can increase system
accuracy.
US METR IC TURF
UNSHIFT SH IFT UNSHIFT SHIFT UNSHIFT SHIFT
METER
CAL
Spreader
Constant
0000 0000 0000 0000 0000 0000
Density
000.0 000.0 0000 0000 000.0 000.0
RATE DISPLAY 0000 000.0 0000 000.0 000.0 000.0
RATE 1 CAL 0000 000.0 0000 000.0 000.0 000.0
RATE 2 CAL 0000 000.0 0000 000.0 000.0 000.0
TANK VOLUME *
0000 | 0000 0000 | 000.0 0000 | 0000 0000 | 000.0 0000 | 000.0 0000 | 000.0
TOTAL AREA 000.0 000.0 000.0 000.0 0000 0000
TOTALVOL *
0000 | 0000 0000 | 000.0 0000 | 0000 0000 | 000.0 0000 | 000.0 0000 | 000.0
FIELD AREA 000.0 000.0 000.0 000.0 0000 0000
FIELD VOLUME *
0000 | 0000 0000 | 000.0 0000 | 0000 0000 | 000.0 0000 | 000.0 0000 | 000.0
VOL/MINUTE 0000 000.0 0000 000.0 000.0 000.0
AREA/HOUR 000.0 000.0 000.0 000.0 0000 0000
RATE +/- 0000 000.0 0000 000.0 000.0 000.0
LOW TANK LEV 0000 000.0 0000 000.0 000.0 000.0
LOW VOL/MIN 0000 000.0 0000 000.0 000.0 000.0
UNSHIFT SH IFT UNSHIFT SHIFT UNSHIFT SHIFT
Spreader
Constant
0000 0000 0000 0000 0000 0000
Density
RATE DISPLAY
0000 000.0 0000 000.0 000.0 000.0
0000 | 0000 0000 | 000.0 0000 | 0000 0000 | 000.0 0000 | 000.0 0000 | 000.0
000.0 000.0 000.0 000.0 0000 0000
0000 | 0000 0000 | 000.0 0000 | 0000 0000 | 000.0 0000 | 000.0 0000 | 000.0
000.0 000.0 000.0 000.0 0000 0000
0000 | 0000 0000 | 000.0 0000 | 0000 0000 | 000.0 0000 | 000.0 0000 | 000.0
DECIMAL PLACE LOCATIONS
* These specified options use both the DATA and RATE displays to enter
and view data.
To Next Page
Loading...
Need help?
General
