ray FACE - Page 85

RAYFace Appendix B. Messages
85
Message
Cause
Guide
Gateway is not on the
same network with the
IP address.
The gateway is not on
the same network as the
IP address.
The IP address and gateway must be on
the same network defined by the
netmask.
Check the network configuration.
Invalid IP address.
The IP address format is
incorrect.
The IP address format is not in the
format (xxx.xxx.xxx.xxx) or the first digit
is over 223.
Enter a valid IP address.
Invalid subnet mask.
The netmask format is
invalid.
The netmask format is not in the format
(xxx.xxx.xxx.xxx) or contiguous.
Enter a valid netmask.
Invalid subnet mask.
The netmask format is
invalid.
The netmask format is not in the format
(xxx.xxx.xxx.xxx) or contiguous.
Enter a valid netmask.
A problem occurred
during serial
communication.
There is a problem with
the scanner firmware.
Update the scanner firmware.
If the problem persists even after the
firmware update, contact your sales
representative.
Firmware is not
responding.
No response from the
scanner firmware to the
serial port.
Check and see if the serial port has been
properly connected to the scanner.
If the serial port is properly connected to
the scanner, restart the scanner.
If the problem persists even after restart,
contact your sales representative.
Unable to open the
COM port.
The specified serial port
is open by another
program or the cable has
been disconnected.
Check and see if there are other
programs using the specified serial port.
Check on the serial port connection
between the computer and the scanner.