RAYFace Appendix B. Messages
86
A problem occurred
during serial
communication.
There is a problem with
the scanner board
installed on the
RAYFace.
Update the scanner firmware.
If the problem persists even after the
firmware update, contact your sales
representative.
A problem occurred
during device setup.
There is a problem with
the scanner board
installed on the
RAYFace.
Update the scanner firmware.
If the problem persists even after the
firmware update, contact your sales
representative.
Settings cannot be
saved because the
device is in use on
another computer.
A capture is in progress
on another computer.
Unable to change the IP address while
capture is in progress on another
computer.
Exit the capure on another computer and
try again.
Unable to initialize the
network device.
There is a problem with
the scanner board
installed on the
RAYFace.
Restart the device.
If the problem persists even after restart,
contact your sales representative.
Unable to save the
network settings.
There is a problem with
the scanner board
installed on the
RAYFace.
Restart the device.
If the problem persists even after restart,
contact your sales representative.
Unable to save the file
with specified path.
The path where the
captured data is saved
has been selected as the
export path.
Unable to export to the path where the
captured data is saved.
Choose another path.
Unable to move the
captured data to the
new path.
A problem occurred while
moving the captured
data to the changed
path.
Check whether there is enough space in
the changed captured data path and the
file can be written.
To Next Page
Loading...
