Chapter 4: Installing the Wheel Pilot 45
4 Installing the Wheel Pilot
Attaching the mounting clevis
1. Fit the mounting clevis to the drive unit using the pin provided.
Then loop the belt drive over the drum and the drive sprocket.
2. Rotate the clutch lever fully clockwise against its stop (i.e. to the
‘tight belt’ position) and then offer the clevis against the vertical
side-wall.
3. Move the clevis down against the side wall until the belt is just
taut. Then adjust the fore-and-aft position of the clevis until the
belt lies parallel to the wheel. To help check if the belt is running
parallel, use a long straight edge such as a sail batten.
D5637-1
Radial offset
D5638-1
81194_1.book Page 45 Wednesday, July 25, 2001 12:10 PM
To Next Page
Loading...
