Chapter 5: Installation
41
Chapter 5: Installation
We recommend that you get an experienced professional, who is
familiar with your boat’s primary steering system, to install your new
autopilot.
5.1 Planning the installation
This chapter explains how to install and connect the following:
•Control head•Fluxgate compass
•Rudder reference transducer•Linear drive
•NMEA interface
Before starting the installation, decide how you will site the units and
run the cables.
EMC installation guidelines
All Raymarine equipment and accessories are designed to the best
industry standards for use in the leisure marine environment.
Their design and manufacture conforms to the appropriate
Electromagnetic Compatibility (EMC) standards, but correct
installation is required to ensure that performance is not compromised.
Although every effort has been taken to ensure that they will perform
under all conditions, it is important to understand what factors could
affect the operation of the product.
To minimise the risk of operating problems:
•All Raymarine equipment and cables connected to it should be:
• At least 1 m (3 ft) from any equipment transmitting or cables
carrying radio signals e.g. VHF radios, cables and antennas. In
the case of SSB radios, the distance should be increased to 2 m
(7 ft).
• More than 2 m (7 ft). from the path of a radar beam. A radar beam
can normally be assumed to spread 20 degrees above and below
the radiating element.
• The equipment should be supplied from a different battery than the
one used for engine start. Voltage drops below 10 V in the power
supply to our products can cause the equipment to reset. This will
not damage the equipment, but will cause the loss of some
information and can change the operating mode.
136_3c05.p65 14/06/99, 10:1641
To Next Page
Loading...
