Chapter 5: Installation
57
5.6 NMEA interface
ST5000 Plus will accept navigation data in the NMEA format for use in
Track Control and Windvane modes. The required data formats are
shown in the table at the end of this section.
Cabling
The NMEA data port is on the rear of the ST5000 Plus and should be
connected to a Position Transducer or Wind Instrument.
Red
(Data In +ve)
Blue
(Data In -ve)
D3374-1
Navigator
with NMEA output
NMEA data transmission to other equipment
If you wish to transmit NMEA information to other equipment a
SeaTalk Interface (Z290) should be installed.
136_3c05.p65 14/06/99, 10:1757
To Next Page
Loading...
