Chapter 6: Post Installation Procedures
61
• The signals being received by the navigator are too weak for reliable
navigation. Refer to the navigator handbook for further action.
Wind transducer interface
If the ST5000 Plus is connected to a wind instrument via its NMEA
data port or SeaTalk, then the link between the two instruments should
be checked as follows:
Press standby and auto together.
The ST5000 Plus should display the Vane mode screen, with the
locked wind angle and locked heading as shown.
Alternatively, if the wind data is not received , the ST5000 Plus will
display a NO DATA error message.
SeaTalk interface
If the ST5000 Plus has been linked to other SeaTalk instruments via
SeaTalk, the link can be checked as follows:
1. Press standby .
2. Select display illumination level 3 on any other SeaTalk instrument
or autopilot control unit.
The ST5000 Plus should immediately respond by switching on its
display illumination.
136_3c06.p65 14/06/99, 10:1761
To Next Page
Loading...
