34 ST5000 Plus SailPilot Owner’s Handbook
• Press disp to move on to the next Data Page selection screen, and
repeat the selection procedure.
Note: If a man overboard (MOB) message is received by the autopilot,
the BTW and DTW pages will display the bearing and distance to the
MOB location, so it is good practice to retain these pages for display.
4.2 Dealer setup
Dealer Setup allows you to customise the autopilot to your boat.
However, the factory default settings will provide safe performance for
the initial sea trial, and fine tuning is not normally required.
The flow chart on the following page shows you how to enter Dealer
Setup, scroll through the setup displays, adjust the values and exit.
The features that can be adjusted are listed in the table following the
flowchart. If you change any of the settings you can record them in the
New Setting column for future reference.
Information on the functions of the different settings is given in the
remainder of this section. The following points should be noted:
• Make sure that the autopilot is in Standby mode before you access
Dealer Setup
• Setup options are always saved on exit
136_3c04.p65 14/06/99, 10:1634
To Next Page
Loading...
