66 ST5000 Plus SailPilot Owner’s Handbook
D3458-1
This shows the maximum deviation detected, and indicates that
compass correction has been completed successfully.
Note: If the deviation value exceeds 15° or a deviation value is not
displayed at all, you should consider moving the fluxgate compass to a
better location.
7. Press the disp key to move on to the Heading Alignment page.
D3459-1
ALIGN HDG
8. Use the +1 and +1, keys, or the +10 and -10 keys, to increase or
decrease the displayed heading, until it agrees with the ship’s
steering compass or a known transit bearing.
9. Press and hold standby for 2 seconds to exit calibration and save
the new settings.
Note: Setup options are always saved on exit.
136_3c06.p65 14/06/99, 10:1766
To Next Page
Loading...
