Chapter 4: Calibration 37
Factory defaults
You can use this screen to reset the operating parameters to the factory default
values. Use the
track and reset keys to make the required selection.
Note that the selection you make at this screen will be applied when you exit the
screen, so be sure you make the correct selection.
If you want to apply the factory defaults, ensure the display shows YES , but if
you want to retain the current values, ensure that the display shows
NO .
Leaving Dealer calibration
Hold down the and keys for 2 seconds to save your settings, exit Dealer
calibration and resume normal operation.
81039_4.book Page 37 Wednesday, March 24, 2004 3:14 PM
To Next Page
Loading...
