28 ST60 Multi Instrument Owner’s Handbook
Procedure
To carry out a User calibration:
1. Power up the ST60 Multi instrument.
2. Press the and keys for approximately 2 seconds so that the User cali-
bration entry screen is displayed.
Note:
The User calibration entry screen will time out to the main display after 7 seconds.
3. Press the key to proceed. During calibration, refer to the
User calibration
diagram, carry out the calibration procedure. Use the key to cycle from
screen to screen and the
track and reset keys to set the required values.
Chapter titles
Select either ON so that each chapter title is displayed when it is selected, or
OFF if you do not want chapter titles to be displayed.
Heading type
Use this to define how headings are displayed, either magnetic (MAG) or true
(TRUE). If a variation value is not available, then MAG is selected permanently.
Battery alarm threshold
The recommended setting is 10.5 VOLTS.
Alarms on/off
Determines whether or not the ST60 Multi instrument will give alarm indications.
The following alarms will occur irrespective of the setting here:
• Pop up pilot alarms.
• External alarms, provided this option is fitted and enabled (see
Select NMEA
or auxiliary alarm
on
page 31
).
Date format
You can set either United States (MM/DD/YY) or European (DD/MM/YY) date
formats.
Time format
You can select either 12-hour or 24-hour time format.
81039_4.book Page 28 Wednesday, March 24, 2004 3:14 PM
To Next Page
Loading...
