22 ST60 Multi Instrument Owner’s Handbook
it is only suitable for use in positions where the instrument will not be exposed to
water.
To bracket mount your ST60 instrument, do so in accordance with the Control Unit
Mounting Bracket Instruction Sheet.
Auxiliary alarm option
The Auxiliary Alarm is waterproof and can be mounted on a panel either above or
below deck, as follows:
1. Drill a 7/8 in (22 mm) diameter hole through the mounting panel as shown.
2. Place the foam seal in position on the back of the Auxiliary Alarm.
3. Feed the two-way connector block and connecting wires through the drilled
hole.
4. Place the Auxiliary Alarm in position with the foam seal between it and the
mounting surface, and secure it using the four self-tapping screws (supplied).
5. Connect a 2-core cable to the connector block and run the other end of the
cable to the rear of the ST60 Multi instrument. The manner in which you run
45mm (1.8in)85mm (3.35in)
D4411_1
Auxiliary Alarm
55 mm
(2.15 in)
Auxiliary Alarm wiring
D4412-2
Auxiliary
Alarm
Foam gasket
Connector block
81039_4.book Page 22 Wednesday, March 24, 2004 3:14 PM
To Next Page
Loading...
